sulo1544 0 Posted June 24 plc ile pc arasında ethernet girişleri ile bağlantı kuramıyorum Quote Share this post Link to post Share on other sites
Hansem 9 Posted June 24 Daha detaylı bilgi verir misiniz? PLC GMTSuite ile çalışır hale nasıl getirildi? PLC nin run-ethernet ışıkları düzgün yanıyor mu? PC niz de statik IP ayarlanmış olabilir mi? Quote Share this post Link to post Share on other sites
sulo1544 0 Posted June 24 evet erhernet ışıkları düzgün yanıyor bu statik ıp nasıl kaldıracaz acaba? Quote Share this post Link to post Share on other sites
sulo1544 0 Posted June 24 büyük bi ihtimal static ip verdim yeni kullanmaya başladımda o yüzden alışmaya çalışıyorum Quote Share this post Link to post Share on other sites
sulo1544 0 Posted June 24 sabahtan sizin arkadaşlardan 1si düzeltmişti ama gene muhtamelen yanış bi yerlere kendim bastım Quote Share this post Link to post Share on other sites
malikenes 21 Posted June 24 CPU üzerindeki switch' e basılı tutarken enerji kesip verin ve 20sn kadar basılı tutun, cihaz otomatik IP ye dönecektir. Quote Share this post Link to post Share on other sites
sulo1544 0 Posted June 24 bilgisayarda ağda problem varsa bunu nasıl çözebiliriz peki Quote Share this post Link to post Share on other sites
sulo1544 0 Posted June 28 (edited) her 2sinide denedim hala bağlamıyorum plc ile bilgisayara nasıl düzelticem acaba bu sorunu Edited June 28 by sulo1544 Quote Share this post Link to post Share on other sites
malikenes 21 Posted June 30 Firmayla irtibata geçin bence. Sabah düzelten o arkadaş bi baksın. Quote Share this post Link to post Share on other sites